Since you are only putting down stair treads pl premium will give you the strength you need to give maximum support of the step and you probably dont need the elasticity because im assuming its one single board for you tread meaning the board expands as one piece.
Can you glue down stair treads.
Stair treads are attached to the stair risers in different ways.
Using a trowel spread some glue down.
The sweeping staircase with a broom to remove dust and dirt so mop.
Using adhesive helps reduces sounds on the stairway such as wooden treads creaking because of loose nails or screws.
Pl premium is what i would recommend if you cant find it the difference is the floating glue has more elasticity to it and is what you want for joining hard wood.
If you use these ultra low voc adhesives you will almost certainly have warping and cupping issues causing you to have to replace your installation.
Tread lock has good grab strength while wet and cures quickly to form a tenacious bond.
With the right glue and epoxy nose caulk they are easy to install.
Glue down vinyl products don t have an adhesive back so you have to put glue on the substrate underlayer first.
You want the ground layer to have an even layer of glue with no air bubbles.
View stair treads factory finished suppliers.
Water based or low voc adhesives substitute water for solvent in the adhesive and the excess moisture will cause your treads to severely warp and buckle.
Apply wood glue to the two shorter sides of each glue block and then firmly press the blocks into the right angle created by the meeting of the riser and the tread.
Position one block in the.
A water free adhesive helps prevent the tread from warping because of moisture.
Set the stair tread in place and tap the front edge with a rubber mallet to form a bond with the glue and the riser.
If you re using sheet vinyl you need to start on the inside of the stair s l shape.
Tap along the top of the tread at the stringers to form a bond with the glue.
Use generous amounts of adhesive to account for the lack of glue blocks.
The top tread on the stairs that cannot be accessed from underneath cannot be glue blocked.
Support blocking can be added to the side of the stringers to increase surface contact for gluing.